AM.CO.ZA (V6-LABEL/A3) V-Auto A3 Automatic Continuously Sheet Feed (ASF) Label Cutting Machine

restart and "crash" will appear.

2, the external 220V input voltage interference is too large, there will be a crash, check

the surrounding 220V, the solution can use AC purification voltage regulator

power supply.

Q: Why do machines sometimes feel numb to the touch?

A: It is caused by poor grounding of the power supply. Please make sure that the middle

line of the power supply is grounded.

Q: Why will the sharp corners be picked up when cutting characters, not smooth?

A: 1, the knife tip extends the knife sleeve is too long, please adjust according to the

regulations.

2, the knife wear, replace the knife can.

Q: Why do die cutting machines sometimes draw a line before they can be engraved and

output?

A: Because the last engraving abnormal exit, in the engraving machine memory did not

clear the knife instruction. The solution is turn off the power and turn it on again to re-

print the output.

Q: Does the LCD display nothing or a small row of black blocks?

A: 1,If no display is displayed, the power supply may not work. Check whether the power

supply works normally.

2, black block display please check the power supply voltage is normal? If the problem

persists, please contact the maintenance station.

Q: Why does cutting sometimes not close?

A: The cutter cutter is an eccentric cutter and has an eccentric value, so the cutter will not

close. The solution is to set "closure compensation" in the software.

For example, in Wentai software:

- 22－ AM.CO.ZA / Sales WhatsApp 060 600 6000 / Support WhatsApp 060 600 7000

22